Combined Milling & Cuttting Machines
In stock
by Nehmeh
On Request
The multiple milling machine OMEC F9 is used to make parallel indents for door frames and other furniture pieces. The machine is equipped with a cutter unit and two saw units to allow the machining of 45° cut. The F9 model machine automatically single both cases and single crosspieces. The locking of the pieces takes place automatically at the beginning of each cycle. The same takes place for the release of the pieces at the end of each cycle. Controls are located on a built-in control panel. The F9 model is controlled by a numerical control system which is entrusted with the working cycle control
DIMENSIONAL LIMITS OF THE WORK PIECES
Dimensions
Length
Width
Indents
CaseThickness
CrosspieceThickness
minimum
500mm
100mm
50mm
30mm
maximum
2500mm
290mm
If you are not Verified Buyer then Please Verify Your Email to get Quotes from Verified Suppliers.